66e bigbore sleeve question

[WaveDemon]

i thought you were going to put the 1300 cyl on there?
i just picked up a set of 3 on gh for 345
2 of them are in primo shape #3 has some issues
prob gonna be dropping on my 66e soon

that is a great deal. I haven't found them that cheap. I think I paid 100 for a bad cylinder with no piston.

I think I"m going to cut the bottom of my 800 cylinder to get the port timing close to the 1300. just weighing out my options.

 

[WaveDemon]

Btw replating runs about $135.00 per hole,so buy the custom sleeves if you want ,you are not coming out cheaper to do so.

I am coming out cheaper with a sleeve.

 

[WFO Speedracer]

I am coming out cheaper with a sleeve.

If you say so Tim.:stups:

 

[Watcon]

Big bore sleeves

I have numerous sleeves available.. Big bore for Flat-top and conventional motor configurations. My sleeves are pre-ported to give you a starting point, and are manufactured for me by NW Sleeve.
The website isn't up to date, but it gives you a rough idea.http://www.watcon.com/Catalog_Pages/Cylinder_Sleeves.htm

wcc@watcon.com

Thanks,
Randy