Super Jet 701 crank front bearing

[Forrest McLauchlin]

has anyone replaced the stator side outer crank bearing? And where to get it?


Sent from my iPhone using Tapatalk

 

[River Rat]

I'll add to this...

Anyone have a video of either a press on or heat and also removal.. coolthxbye

 

[JetManiac]

We stock the front and rear replacement crank bearings. There is a special tool to remove them and use a press to install them. There may be other ways to do it.

 

[Forrest McLauchlin]

We stock the front and rear replacement crank bearings. There is a special tool to remove them and use a press to install them. There may be other ways to do it.

Price on bearing and tool?


Sent from my iPhone using Tapatalk

 

[tntsuperjet]

You use a standard bearing clamp to remove the bearing.
Press the old bearing off after u tighten the bearing clamp up with wrench till it in seats the bearing.
NOTE!!!!!
Do not press the new bearing on or you may damage the crank

 

[tntsuperjet]

You cannot press on the full length of the crank shaft or you will pinch the pin bores and the crank will be out of true.
You have to put the crank in freezer for about an hour and heat the inner bearing race to 200 deg F with small butane crack torch.
Be careful not to put any heat on bearing race cage.
The bearing will slip right on.
Soon as u get bearing on cool with compressed air to keep the heat from migrating into the bearing cage.

 

[River Rat]

Ah man thanks a Lot Tim.