760 help

[NicDuncan]

I pulled my 760 to do a carb rebuild then I found my intake hose was cracked so I pulled everything out but I'm currently having issues figuring where some of the hoses go, might even have my other hoses wrong does anyone have a diagram or can you send me pictures of where your intake pipe lines go and which fuel lines go where please and thank you really itching to ride this week before it gets too cold

 

[Big Kahuna]

Not sure what you are referring to by "Intake Pipe"

 

[NicDuncan]

Not sure what you are referring to by "Intake Pipe"

Sorry the water lines I believe, I need to know which fuel lines go where as well as the water lines I think they are, also the line that connects to the back on the hull behind the engine not sure what that one is, I'm a Newby I apologize

 

[NicDuncan]

Wow I meant exhaust lines sorry that was stupid of me lol

 

[Mike W]

If you look on the fuel pump side of the carb you will see arrows indicating which one is the supply and which one is the return. The pulse line is the only one left.

As far as your cooling lines, can you post a picture of your setup?

 

[Wizards Powersports]

Fuel in is the bottom nipple on the carbs (760 stock setup is one line in, with a T splitting to both carbs. Return is the top.

 

[NicDuncan]

.

 

[NicDuncan]

.

 

[NicDuncan]

That line from the bottom box to the rear wall does that just sit in the corner behind the exhaust? Feel the exhaust heat would be a problem

 

[NicDuncan]

Also where do you have this wire ran just feel it's too close to the exhaust

 

[Big Kahuna]

On the last pic. Tuck it behind the Ebox. As far as waterlines. You either have dual cooling or single cooling. On the right side of your pump there is a waterlone going to the thru hull waterline that comes out inside hull on right side. This line will go to the exhaust manifold. From there you come out of the head down to the rear of the expansion chamber of the pipe. On that pipe there is a waterline that will come out the top front of the chamber and goes to the stinger of the pipe (closest to end of pipe at waterbox hose). Right before this you will have a fitting that comes out of the waterjacket of your dry pipe chamber. This will dump overboard.

Sent from my SAMSUNG-SM-G930A using Tapatalk

 

[NicDuncan]

So the nipple on the top left of the head(closest to electrical box) goes to the "expansion chamber) closest to the exhaust manifold? And do I have the lines correct on the first picture one to the right side of head and the exit out the side of the hull