800 X2 pipe conversion

[winterstick]

hi pipe pros
i'm thinking of getting a blaster limited pipe, but was wondering if you can weld up the end where the stinger is and put the outlet on the bottom as a centre bleed style, to make it fit, so it will look a bit like the sxr wet

 

[ROTATION]

Yes you can, that will make it like a FP WB1 Mod-pipe, you will also get reduced noise.

 

[winterstick]

there is a water inlet on the stinger as well, that should go where if i move it

 

[shepster]

Hi, Same place as before, next to the outlet .

 

[winterstick]

here's what we ended up doing

 

[winterstick]

put it in one of these, bolt one of these on the back, hope it works out

 

[winterstick]

work till its late, no test ride, and then load up and go racing

 

[tricky1]

hi pipe pros
i'm thinking of getting a blaster limited pipe, but was wondering if you can weld up the end where the stinger is and put the outlet on the bottom as a centre bleed style, to make it fit, so it will look a bit like the sxr wet

I have one also if you need another.

 

[winterstick]

I'll keep it in mind as we are going to try the SXr wet to see the difference

 

[Scraggly]

nice x2!!

 

[winterstick]

the thing was flying, rider says it was faster than his dry piped SXR with the same engine, but the head pipe to manifold bolts came loose, then the head pipe cracked at the mounting flange where the outer rear bolt goes through and couldn't finish the day