94 WB1.... my first real build

[blaster4life]

i figured i would start a thread on my blaster build...feel fre to chime in with comments. i have the haul stripped and the back cut out. i'm gettin rid of the lip and putting a rear carbon fiber exost... and carbon reenforcing the hull....alos putting on cats trim and getting the motor work done by group k... i want to backflip....bad

 

[blaster4life]

rear lip fill

 

[blaster4life]

more pics of what i have done so far today

 

[bad93blaster]

cant you get a better pic of the exhaust flange

 

[blaster4life]

i sure can..... but i brought it to a buddys housse and left it there....i need to get it back..... i don't need it yet so i just havn't gotten around to it... i will

 

[blaster4life]

the back after i trimmed the carbon.... i will be putting a peice in the middle the one more over the whole back..... i will also put atleats on layer on the inside...think i should do 2?

 

[blaster4life]

secon layer of carbon

 

[blaster4life]

third and last layer of carbon on the back..... i'm going to do two layers on the side streching from the back 50 inches out

 

[blaster4life]

pics ...

 

[blaster4life]

the right side 1st layer ofr carbon

 

[blaster4life]

the back done...and the last layer of carbon on the right side

 

[blaster4life]

left side done with 2 layers of carbon and carbon reforce the hood lip

 

[blaster4life]

well i spray gel coated the bottom to night but my carmra phone broke.. i will have pics up 2morrow

 

[JetAholic]

Did you ever finish the ski??? I am looking to reinforce my B1, it has been getting beat up in the surf pretty bad...

 

[blaster4life]

nope not yet...i was laid off all summer and ran out of cash. Now that i'm working again my girlfriend is pregnat. I might be parting the ski out........i have aot of good parts i will be selling if i decide to part it. UMI steering with brand new seald bearings, Riva water box, New ADA girdled head with 2 sets of domes,MDS, group k ported cases, real clean 61x complet, most of what ya need for a C.A.T.S. trim, solas prop,, the hull with the carbon on it with the bottom gell coated black with 3 high mettalics stars down the center, all the other parts from the ski, dakin straps, blowsion anodised fitings.... prob some more stuff.

 

[tor*p*do]

nope not yet...i was laid off all summer and ran out of cash. Now that i'm working again my girlfriend is pregnat. I might be parting the ski out.........

bummer, dude, shoulda worn your galoshes

 

[JetAholic]

Pm me some prices on the umi, head and impeller...

 

[blaster4life]

were back on....the dumb b*tch went and got an abortion,,,against my wushes....needless to say i'm single agian and i am so glad i didn't part my ski out........ started sanding the hull last night to add mor gel coat