Other A/M Carb Kit Questions for GP1200R SBN - I

///M5

///M5

Location
Guam
I recently purchased a set of good used carbs for my GP1200R. I opened them up to check everything out, and found them to be newly rebuilt. I do not recognize the carb kits, and judging by the SILVER diaphram pin color they look to be WINDEROSA.

I replaced the metering block rubber gasket (They were already hard) with some good Mikuni ones I had laying around, and was wondering if there is anything else I should replace?

I'm hoping that the kits are okay, but I have Zero experience with them.

Thanks,
 
Last edited:
///M5

///M5

Location
Guam
Thanks for the advice. I'm building the boat, so I have nothing to base off of. Although they are new kits, I'm just wondering if they are known to cause tuning issues. The "Made in the USA" is throwing me off. That used to mean good stuff, but in this case not?
 
Yami-Rider

Yami-Rider

TigerCraft FV-PRO
Location
Texoma
ya that could just mean the box was made in the USA, I have seen that before lol.
Check pop-off, if the gaskets don't leak, then your be good.
 
///M5

///M5

Location
Guam
Yeah will do. I inspected all the check valves, and there aren't any creases or anything. The PO didn't install the filters so I will replace those along with anything else that could be problematic.
 
You must log in or register to reply here.
Top Bottom