ADA/B pipe cooling

[danimal!]

I have a 62T with a single cooling line coming in. I do not want to delete the stock bilge. I am about to install an ADA head with duel cooling. I only have one cooling line coming in. I am wondering what you think about running my cooling lines. I have attached 3 options I feel may work. Just wondering what yall think.

Motor Mods:
Factory limited b pipe
Lighted flywheel
Vforce 3
MSD enhancer
Now installing ADA with 35cc

 

[Mike W]

I have single cooling with and ADA head as well. Go with option 3 and put a restrictor in the front cooling line going to the pisser. It will have plenty of pressure to cool the pipe.

 

[nextlevelinnovations]

Option 3, and tap for additional fitting in pump and run dual cooling

 

[amitchell]

 

[danimal!]

Option 3, and tap for additional fitting in pump and run dual cooling

Where would I run this line. I want to keep stock bilge system. Drill another hole in the firewall?


Sent from my iPhone using Tapatalk

 

[nextlevelinnovations]

Where would I run this line. I want to keep stock bilge system. Drill another hole in the firewall?


Sent from my iPhone using Tapatalk

I'm running dual cooling and stock bilge still on all my blasters. I tapped pump again, drilled hull right above stock bilge line and ran through there. Run the line right alongside bilge line and stock cooling line straight to the mani. Tap mani again and run your second line into that.

 

[danimal!]

I like this idea a lot! Can please you post a picture of your tapped pump?

 

[nextlevelinnovations]

I like this idea a lot! Can please you post a picture of your tapped pump?

I'll be home on Sunday and post a few pics that eve.

 

[dpenta13]

There is a nipple type thing on the oposite side of were your factory water line taps into your stock bilge.
That is were i have seen people tap in for the second water line.

Here is a link i found before showing were to do it.
I would drill a 3/8" OD line and run to engine compartment above your stock bilge line.
Then Tap Mani for second line as stated above.

http://www.dalusionfwx.co.nz/forum/viewtopic.php?t=3203

 

[Mike W]

That's exactly where you tap the second fitting. If you have a electric bilge you can just use the stock bilge siphon line.

 

[danimal!]

Thanks everyone! Looks like its going to be a fun weekend project.


Sent from my iPhone using Tapatalk

 

[Vumad]

Run both lines off the head to a wye single line into the pipe.

If the motor is too hot, you will need a second line in and run the 2 lines out.

 

[Vumad]

View attachment 245948

My ski is 140/75 @ 18 (edit: @42psi) psi. Those specs were too lean for me. Fpp has changed their recommendations to 140 on the top, not sure when, but they have. 135 on my stuck a piston.

 

[amitchell]

Yeah that was more for the cooling routing, but I am running 77.5 and 145. 140 was a touch lean for me.

 

[Boostaholic]

I have the same head and pipe, but i have duel cooling. How should I plumb it? Could sketch me a diagram please