ADA Yamaha Cylinder

W

waxhead

wannabe backflipper
Location
gold coast
hey can you buy the power valve housings you have on that team scream engine seperately
and if so how much
I wish some one made shorter housings to sit closer to the engine and it would help alot with clearance problems
 
IKSTEJ

IKSTEJ

BOGIE
Location
Region 7
waxhead said:
hey can you buy the power valve housings you have on that team scream engine seperately
and if so how much
I wish some one made shorter housings to sit closer to the engine and it would help alot with clearance problems
Click to expand...
You can buy the housing assemblies from Dasa.
There nice
 
D

Don 79 TA

Still Fat....
Location
Madision/Huntsville AL
Idok said:
X-Scream...

Have you guys built any single carb surf based motors???
Click to expand...

you know i was going to ask something along the same lines...

anyone running a single carb on a stroker/big bore
like these larger CC motors?

If i decide to rebuild mine, i was pondering the thought of being able to run a big single carb (if its possible)
 
IKSTEJ

IKSTEJ

BOGIE
Location
Region 7
If I remember correctly the ADA cylinder Chuck built for NJFL was a single.
We've been building them for RR, on 785's, and 5mm strokers.
Anything bigger than that and we like the twins.
the first engine chuck built for me like 10 years ago was a single, but I've been using twins since.
 
crammit442

crammit442

makin' legs
Location
here
IKSTEJ said:
If I remember correctly the ADA cylinder Chuck built for NJFL was a single.
We've been building them for RR, on 785's, and 5mm strokers.
Anything bigger than that and we like the twins.
the first engine chuck built for me like 10 years ago was a single, but I've been using twins since.
Click to expand...

It was and it ran pretty decent. It was an old style ADA 6mm/85.5.
 
P

PancakePete

Guest
I liked that motor too. Snotty for flat, but smooth so you could Surfed the crap out of it !
 
P

PancakePete

Guest
crammit442 said:
Chuckie built the first ADA that Joe had. That's the one Pat is talking about. It was an old style ADA cylinder. After that, Art at Jetworks built him one of the new ADA cylinders. That one really rips!:smoker:
Click to expand...

werd. one was 6 mil and the other 10 or 8 ?
I rode that one too. that is narly too !:bigok:
 
IKSTEJ

IKSTEJ

BOGIE
Location
Region 7
Nice avatar pete. Is that Pauls new girl :biggrin:

Heres a pic of the just ok 6mm
 

Attachments

  • 6mil.jpg
    6mil.jpg
    94.7 KB · Views: 99
Last edited:
D

Don 79 TA

Still Fat....
Location
Madision/Huntsville AL
i had a feeling with the larger CC's a single card would cut or be difficult to get set right.
when i went to the ported 760 we tried single, and it was like hit or miss with it (this was before these larger singles now)
probably smaller CC's reap a better benefit...

Bogie...
We need to hook up at Havasu...
definately interested the options out there...
both motors needs a little TLC... mine is due (but hot dam it is still strong)

also, can you help me verify my new compression gauge? just got a new snap on one and want to make sure it compares to other gagues.....
 
You must log in or register to reply here.
Top Bottom