Adding dual pulse line fitting

[Davidomilligan]

Are you guys putting it in the same location on the other other side as the left side ? Can I drill it in flat spot ?

Sent from my XT1650 using Tapatalk

 

[Harbor]

Yes same spot as other side, like in your first pic, here's mine, one pic is straight down the other from front best I could get..., my pics are dark, first pic you can see the black pulse line, it has a shiny silver under it right at the case

 

[Davidomilligan]

Ya I guess mine are an older set of cases that dont have the raised ledge so gotta figure out how to get the bit to bite

Yes same spot as other side, like in your first pic, here's mine, one pic is straight down the other from front best I could get..., my pics are dark, first pic you can see the black pulse line, it has a shiny silver under it right at the case

View attachment 354728View attachment 354729

Sent from my XT1650 using Tapatalk

 

[Harbor]

You could use a dremil bit or carbid cutter to start a counter sink or a pointed punch to center punch a starting point and small drill bit at first and then step up a few times to your final bit

 

[Davidomilligan]

Ya that's what I'm thinking . Headed to grab a but for the Dremel right now

You could use a dremil bit or carbid cutter to start a counter sink or a pointed punch to punch a starting point and small drill bit at first and then step up a few times to your final bit

Sent from my XT1650 using Tapatalk