Super Jet Adding Spitter to SJ 650

djkorn1

djkorn1

kidkornfilms
Site Supporter
Location
Cleveland Ohio
This square 650 has no spitter???? wtf? There are two lines coming out of the back of the ski, is one water intake and one spitter into the pump? or is it dual cooling.

The ski is completely stock except intake, rideplate, impeller, flame arrestor.
 
oxnard111

oxnard111

Creative RE Purchasing
Location
so Cali, Ventura/Oxnard area
djkorn1 said:
This square 650 has no spitter???? wtf? There are two lines coming out of the back of the ski, is one water intake and one spitter into the pump? or is it dual cooling.

The ski is completely stock except intake, rideplate, impeller, flame arrestor.
Click to expand...

One is water intake while other is the syphon bilge...

You are correct they did not come with a bypass... You can either tap the cylinder head or there is a plugged fitting on the back inside section of the pipe... kinda near the rubber elbow... you can purchase a flush kit to plug into there put a bypass... Or you can cut the line running from the top of the head into the pipe and put a "t" fitting there also that would lead to a bypass.
 
SJBrit

SJBrit

Extraordinary Alien
Location
Bradenton, FL
DJ: just go ahead and T off the pipe that goes to the head and run that to a bypass - that's what I did on my 650.

Sent from my T-Mobile myTouch 3G Slide using Tapatalk
 
djkorn1

djkorn1

kidkornfilms
Site Supporter
Location
Cleveland Ohio
SJBrit said:
DJ: just go ahead and T off the pipe that goes to the head and run that to a bypass - that's what I did on my 650.

Sent from my T-Mobile myTouch 3G Slide using Tapatalk
Click to expand...

The line is like 1/16" thick????? Its SUPER tiny....don't know if I can even get a T that thin...
 
djkorn1

djkorn1

kidkornfilms
Site Supporter
Location
Cleveland Ohio
Aha...found it. Thanks Brit and Boom...it was covered with that plastic wire covering.... so I shouldn't use the flush kit line?
 
You must log in or register to reply here.
Top Bottom