- Location
- New York
I have the ability run sets if there is enough interest for them. Price would be 59.95 plus shipping. Will be waterjeted out and powder coated.
Anyone sell a block off kit for leak down testing?
- Thread starter kawa js550
- Start date
- Location
- Stony Plain, Alberta, Canada
What size did you use for the B-pipe manifold and the carbs? Think I read B-pipe manifold is 46mm (1.811"). I have 38mm carbs and not sure what the hole size is. Ski is stored at my parents and won't be there for awhile. Thanks!
- Location
- Downers Grove
I just 3d printed some out. Used some 1/8" rubber sheet and its good to go
- Location
- Wichita ks
I just use old mx tube between the b pipe manifold and head pipe , then plumbing plugs for the intake manifold
- Location
- Granbury, TX
Make your own. Use 1/8 or 3/16" rubber sheet off Amazon. I have a a set for every type of motor I've worked on.
