- Location
- Harveys Lake PA
Pre preg is way too expensive to be building skis with. I'll stick with infusion.
Attention engineers, curing oven controls.
- Thread starter Brian_216
- Start date
Schmidty721
someone turf my rails
- Location
- WI
Thought maybe you guys were doing your own pre-preg with a high temp cure resin.
- Location
- Harveys Lake PA
It can be done. I just got hooked on infusion. There is so much more control of the layup, and no time window until you mix resin.
- Location
- Texas
This interests me as well. I've been in contact with omega and a couple of distributors for a similar solution.
I'm looking into integrated mold heating for a simplified prepreg compression mold on smaller parts. Infusion doesn't scale down well for smaller/cheaper parts. Labor and mold cycle time seem to be the limiting factors.
Very interested in what you end up figuring out for your setup Brian.
I'm looking into integrated mold heating for a simplified prepreg compression mold on smaller parts. Infusion doesn't scale down well for smaller/cheaper parts. Labor and mold cycle time seem to be the limiting factors.
Very interested in what you end up figuring out for your setup Brian.
- Location
- Harveys Lake PA
I'm going simple. Wind up light switch timer and an old school oven thermostat with a knob and numbers on it. Keeping it simple.