B pipe screw settings
- Thread starter Jameski
- Start date
Sanford
ECF
- Location
- Freeride capital of the world
Everyone has their "preferred" way of running the screws. It is all based on top, mid or bottom end. There really is no magic bullet. Experiment.
As a general rule the closer the adjustment screw is to the manifold will provide more bottom end. Also the more water introduced = more bottom.
Top end:
Close top and mid screw and open bottom screw until water just sizzles on chamber.
Bottom end:
Close bottom and mid screw and open top screw so the chamber is hot to the touch (but no sizzle).
How I've always run my FPB:
Closed mid, open bottom till sizzle then open the top screw till pipe is hot or warm.
I like to balance the water between 2 screws so if one gets clogged, it won't melt hoses.
As always, YMMV
FYI: Download manual here
As a general rule the closer the adjustment screw is to the manifold will provide more bottom end. Also the more water introduced = more bottom.
Top end:
Close top and mid screw and open bottom screw until water just sizzles on chamber.
Bottom end:
Close bottom and mid screw and open top screw so the chamber is hot to the touch (but no sizzle).
How I've always run my FPB:
Closed mid, open bottom till sizzle then open the top screw till pipe is hot or warm.
I like to balance the water between 2 screws so if one gets clogged, it won't melt hoses.
As always, YMMV
FYI: Download manual here