B1 Finally Done and For Sale

T

tall1

Location
NE Ohio
Well here is my winter project all shiny and new(kinda). And unfortunatly I have to let her go. Anyhow I hope you guys like it. Here what it's got.
'94 Blaster Fresh paint base/clear, New seat cover prof. install, motor is fresh less than a tank through it.
62T/61X 2mm over,5mm Protec crank(welded),cyl. and case ported by Protec,Protec head and girdle 200psi.(billet MRD head on the way to get the comp down to 185ish)
Riva Pipe and waterbox
New MSD CDI and Enhancer
Dual 44's w/Riva Fa's and Primer Jetting is Protec spec.

Protec ride plate and intake
Impeller aftermarket but I don't know what it is.

I'm sure I'm forgetting something but thats the bulk of it. And I have no idea what to ask for it so any imput would be greatly appreciated. Thanks for checking her out.
 

Attachments

  • WB.jpg
    WB.jpg
    66.3 KB · Views: 445
  • WB2.jpg
    WB2.jpg
    71.6 KB · Views: 242
  • WB5.jpg
    WB5.jpg
    69 KB · Views: 456
  • WB4.jpg
    WB4.jpg
    58.3 KB · Views: 196
T

tall1

Location
NE Ohio
I'll get some to you tonight. The manifold is red pipe is silver. The guy I talked to at Protec new exactly what was on it. So that must have been "the" pipe that they used for the strokers.
 
T

tall1

Location
NE Ohio
To be honest I don't really know what it is worth. I am open to offers and input on what its value might be. I have thought about asking $3500-$4000 but I don't know if I'm off base or not. I know I couldn't replace it for that.
 
T

tall1

Location
NE Ohio
No I didn't paint it. My ex father in-law owns a chevy dealership and they did it in the body shop. The graphics are from ebay. I wasn't impressed with the quality. Must be bottom of the barrel 3M. Very thin and hard to put on. I even used alcohol/water mix and a heat gun and still couldn't get the large tuning fork graphic on. Not impressed at all especially for what they cost.
 
You must log in or register to reply here.
Top Bottom