B2 1100

[Christopher]

Whats up!

Planning on a B2 1100 conversion, my 1st one. Any information that I need to know?

 

[Sasquachcrap]

Just did one last year. Great set up. What are you looking to use it for? The ski is a nose heavy ski. We used the Ada conversion brackets and dropped it in. Had to be the easiest swap ever.

 

[Sasquachcrap]

 

[Sasquachcrap]

If I had to do it again I would cut and weld a plate between the bed plate motor mount bolts then just redrill the motor mount hole. You could move the motor back a little by doing this and I think that would help the ski ride a little better. It would also require a shorter midshaft. Which I can make and sell you one if needed.

 

[Christopher]

If I had to do it again I would cut and weld a plate between the bed plate motor mount bolts then just redrill the motor mount hole. You could move the motor back a little by doing this and I think that would help the ski ride a little better. It would also require a shorter midshaft. Which I can make and sell you one if needed.

I have a shorter mid shaft ready to go. (64U) I think. I knew about the conversion kit from Blowsin but am kinda liking the plate setup you have.

Can I use the same water box? What about the prop?

 

[Christopher]

Just did one last year. Great set up. What are you looking to use it for? The ski is a nose heavy ski. We used the Ada conversion brackets and dropped it in. Had to be the easiest swap ever.

I wanna treat this like a hot rod. Make it all pretty and such. I have a B2 that Inuse for wave jumping in Lake Michigan with. Looking at going after a B1 to replace the B2 though. I'm only about 2 years into the sport so all this is new and this will be my 1st solo build

 

[Dools]

Sweet, I love the size, stable float, and ergonomics of my WB2 ... it just needs more umpf.

Looking forward to see this!

-Dools