Custom/Hybrid backie chan dash

[mike b]

More air the better just make the tube go to the bottom of the hull yea my kdx had 3 xmetal tubes and the pole tubes

You had a TPE with dual 49s too right? I haven't assembled my ski still waiting on the motor but wanted to get a few things done to it before my motor comes

 

[Schmidty721]

I run my primer and bilge pump switch inside the engine bay. I'm there to power up the total loss anyways. I leave my bilge pump run the whole time I ride. As others state, hood comes off everytime I'm back to shore anyways.

 

[Byeai]

Yup I have it but it's here for now

 

[Byeai]

This is the chan hood breathers

 

[mike b]

^least you have one to look at haha. im stuck with pictures for a little bit longer. Ohh well, I still have a good size list of things to do before im ready to drop in a motor anyways

 

[Byeai]

This is the kdx hood breathers

 

[mike b]

This is the chan hood breathers

I like them in a line along the side but i didn't put the first holes in so have to go along the lines i already have. I think ill just throw on that 3rd tube encase i ever upgrade but is it the size motor or size carbs that dictate the amount of air needed?

 

[Byeai]

Yea you no a motor is basically a big air pump so the more air the better but u have to also limit water intake so that's y u want the breathers long

 

[mike b]

Yea you no a motor is basically a big air pump so the more air the better but u have to also limit water intake so that's y u want the breathers long

Yeah the length is for when its upside-down that the tubes are above the water level right?

 

[Byeai]

Yea and when u flip it over any water will go down to bottom of hull and out the back