- Location
- Near Seattle WA
Sleeves
I have sleeves in stock that will accept up to 86+ mm pistons, and are pre-ported to make life easier. You can either "drop them in" or re-port to your specifications. They are a slightly different composition than most sleeves available, and hold their bore tolerances a little better. The upper lip of the sleeve is also wider for a better "O-ring" seal. The labors prices need to be updated on my site, but the sleeve prices are accurate.
http://www.watcon.com/Catalog_Pages/Cylinder_Sleeves.htm
Contact me directly at wcc@watcon.com
Thanks,
Randy
I have sleeves in stock that will accept up to 86+ mm pistons, and are pre-ported to make life easier. You can either "drop them in" or re-port to your specifications. They are a slightly different composition than most sleeves available, and hold their bore tolerances a little better. The upper lip of the sleeve is also wider for a better "O-ring" seal. The labors prices need to be updated on my site, but the sleeve prices are accurate.
http://www.watcon.com/Catalog_Pages/Cylinder_Sleeves.htm
Contact me directly at wcc@watcon.com
Thanks,
Randy