Super Jet bent rod

[Half flip95]

my buddy filled her up with water and cranked on the starter a bit.

Who do ya think has the fastest turn around on a crank rebuild right now?

 

[Yami-Rider]

What motor? If its a yamaha, i would almost bet its not bent. I have hydro-lock/sank my RN about 6 times or so, get the water out and run it. My still runs great.

 

[JetManiac]

my buddy filled her up with water and cranked on the starter a bit.

Who do ya think has the fastest turn around on a crank rebuild right now?

Have you verified that the rod is bent? Rebuilt cranks in stock if needed.

 

[tomski]

If you are in Havasu I have ADR in stock. Plus oem crank seals and all gaskets.

 

[ajmps1]

Pics of carnage

 

[Half flip95]

they look straight to me, but could there be minor changes that the eye wont see?

 

[ajmps1]

Was it not running after wards? Or did he just blip the starter and your being causious?

 

[Half flip95]

after pulling it apart the pistons look black + some scuffing

 

[Half flip95]

after it locked up i blew out the water and got it fired. ran it for about 20 mins was 100% ---> slight bog ----> 3 minutes later barely running enough to keep me from getting plowed by hundreds of boats. at first is was a bog then turned to clunking

cranked the starter like 10 + times

we def lost compression so id hate to bore it and have it go out again because the rod is outta whack

 

[senor]

Has the base gasket blew between the 2 ? Looks like it had spit out.

 

[Magyar68]

Pull the engine cover, make sure there is no water on your Stator. You may want to dump your Fuel tank, Water in the Fuel would cause the Conditions you Describe.

 

[Half flip95]

Has the base gasket blew between the 2 ? Looks like it had spit out.

yea the base gasket split. I couldn't tell if tore when i was pulling the cyl off or happened before.

Pull the engine cover, make sure there is no water on your Stator. You may want to dump your Fuel tank, Water in the Fuel would cause the Conditions you Describe.

will do. the head domes and piston tops were pretty wet. even a bit of liquid in the bottom of the cases - couldnt really tell if it was water or fuel. Ill dry everything and do a comp test / fire this evening

 

[Blue]

If u cant see a bend Check squish if both cyl are same the rods probably not bent

Sent from my SAMSUNG-SM-N900A using Tapatalk

 

[Half flip95]

If u cant see a bend Check squish if both cyl are same the rods probably not bent

Sent from my SAMSUNG-SM-N900A using Tapatalk

good call! will do that