- Location
- Farmington Hills, MI
...
Last edited:
Blaster Blaster hooning, UK style!
- Thread starter Superjetjim
- Start date
- Location
- amarillo ,tx
Mines the same way as u r describeing . The line from top of chamber goes to stinger. The other fitting goes over board so 3 pissers total
Sent from my SCH-I535 using Tapatalk
Sent from my SCH-I535 using Tapatalk
- Location
- Farmington Hills, MI
right on, thank you. What stinger mods are you running. What power plant are you running?
- Location
- amarillo ,tx
Sent from my SCH-I535 using Tapatalk
Last edited:
- Location
- Farmington Hills, MI
im thinking the spray bar is the way to go. I just dont know anything about them or water injection...
Went to the lake yesterday guys. I ran both lines off the pump to the manifold. one head fitting feeding the pipe. One pisser from the head and one from the chamber. Ski ran really well; cool motor, warm-hot pipe. Need to re-jet down low I think but other than that everything is great. Thanks again everyone for the help!
- Location
- Washington, PA
Those are some amazingly clean sharp skis getting the 
ridden out of them. I dig it looks fun as hell. Where is this?
ridden out of them. I dig it looks fun as hell. Where is this?
Superjetjim
X-
Thanks Escore, it's a river in England (and some smaller ones that run off it) - epic day, hoping to do it again soon, covered about 20x miles up river that day. Carried extra fuel in engine bay.Those are some amazingly clean sharp skis getting the
Jim