Blaster limited factory b pipe install

[Sjetfactory]

Just bought a limited factory b pipe for my stock 95 b1. Any advice, tips and settings clues before I start install!? What about the jetting?

 

[701dave]

The install is basically straight forward. You will how ever need to re-jet that single carb or run the risk of blowing the motor from leaning out.

 

[Sjetfactory]

Yeah i'm asking for spec like 145 main and 120 pilot ? Should it be a good start? I saw some with a support on the head but mine just got one on the fuel tank. Can this be a problem ?

 

[jetx]

The limited doesn't use a lord mount on the head, only on the gas tank mount so your good.

Go to factory pipes website and pull up the instructions. Jetting specs are in there and start from there.

 

[Sjetfactory]

Ok thanks!!

 

[player1]

The coupler will seperate from the header pipe if you have any grease, or other residue there - Usually when your in the surf.. Clean as possible - then us hair spray to help slide on, when it dries, stickyness.

 

[taylor2000]

If you didn't get the coupler from fp and bought it else where you will need to cut the length you need. I was ordering mine from suppliers not realizing it was too long causing blow outs. Make sure you are using the right hose clamps a swella swell