Blaster Blaster problem need HELP

[Nickyt31]

I hope I out this in the right place sorry if I didn't. So I got a on going problem. I got a 96 waveblaster 1 and the ski runs perfect intil the ski starts going vertical jumping. It keeps hitting the Rev limiter. And if I let it sit for a day it's fine. I have brand new fresh rebuild carbs new fuel line new fuel filter and a new motor. I had this problem since I first got the ski. Any advice????

 

[LBS4]

Hitting rev limiter while in the air? Pulling back out after landing? Runs perfect until it leaves the water then hits limiter after a couple jumps? 20 jumps? Intermittent problem or always the same?
Sounds kinda like loose/corroded wire &/or connection somewhere but I think need more info, unless I'm missing it?
LB

 

[Nickyt31]

Hitting rev limiter while in the air? Pulling back out after landing? Runs perfect until it leaves the water then hits limiter after a couple jumps? 20 jumps? Intermittent problem or always the same?
Sounds kinda like loose/corroded wire &/or connection somewhere but I think need more info, unless I'm missing it?
LB

After I land it will hit the rev limiter for about the rest of the day I can only go about maybe less than half throttle and anything more than that it will start hitting the rev limiter but if I let the ski sit for about 24 hours the next day the ski will run perfect. I don't even have to hit a jump. If I stand on the back if ski and Bob it like a wheelie it will start to hit the rev limiter all day intil I let the ski sit for a long period of time

Sent from my SM-G930V using Tapatalk

 

[LBS4]

Sounds more like something may be going on with temp sensor & putting the ski into limp mode.
LB

 

[Nickyt31]

Sounds more like something may be going on with temp sensor & putting the ski into limp mode.
LB

Is there a way I can just eliminate the sensor. Or do u recommend keeping it?

Sent from my SM-G930V using Tapatalk

 

[Mike W]

Is there a way I can just eliminate the sensor. Or do u recommend keeping it?

Sent from my SM-G930V using Tapatalk

Try removing it from the head and zip tieing out of the way. If it still gives you issues then you can open up the ebox and unplug it from the wiring. However you will need a jumper wire like this one. http://www.x-h2o.com/index.php?thre...the-clean-slate-temp-sensor-delete-kit.84571/

 

[Nickyt31]

Try removing it from the head and zip tieing out of the way. If it still gives you issues then you can open up the ebox and unplug it from the wiring. However you will need a jumper wire like this one. http://www.x-h2o.com/index.php?thre...the-clean-slate-temp-sensor-delete-kit.84571/

I tried to zip tie it to the side. Still same thing. Gonna order from the link u sent me. Thanks

Sent from my SM-G930V using Tapatalk

 

[Mike W]

I tried to zip tie it to the side. Still same thing. Gonna order from the link u sent me. Thanks

Sent from my SM-G930V using Tapatalk

Know OCD Solutions scaled back but he may still have some of those jumpers.

 

[billglass]

Hmm. how neccessary is the jumper. I thought you could just unplug it and tape the ends.??????????????????

 

[smoofers]

The jumper is not necessary at all. If you look at OCD's product the actual jumper is a rubber cord to keep the pink wire insulated from ground.

Unplug the sensor and tape, heat shrink, silicone, or tuck away the pink wire connector so it doesn't touch anything. Boom, sensor deleted.