Blaster

[tnt01]

Pick up a wb1 and so far from what I see is a 62t motor with a Coffman pipe and a auto switch bilge pump with a umi steering..my plans are????I don't know yet...but reading and seeing what u guy are doing with your blaster there alot u can do with this ski..but after my phantom build I am tap out and i'm just going to enjoy the ride....here a few pic I took....

 

[tnt01]

Well it startsdidn't like the turf so I had extra turf,since the old turf was coming off

 

[Mike W]

Good looking paint scheme. I like it.

 

[tnt01]

What will be a better pipe the Coffman or my factory B pipe,still deciding what pipe to run...

 

[jetx]

B pipe forsure

 

[tshank123]

I bet that coffman pipe has better top end. Just sayin

 

[orangefinger]

Great buy !
I would bump compression to get full potential out of either pipe.....

 

[tnt01]

I bet that coffman pipe has better top end. Just sayin

I am sure the Coffman pipe did,the last owner race alot...but this will be build to chase boat and ride the ocean....

 

[tnt01]

Well decided to install the f/b pipe and found some kind off hard epoxy around the carbs I took the motor out to inspect the hole motor to make sure there was no funny epoxy hiding to seal any leak..good new is there was no epoxy on the motor..so I contacted the old owner and agree to get me used set off carbs for the motor...but better sets...that was cool of him to do...

 

[tnt01]

Great buy !
I would bump compression to get full potential out of either pipe.....

That the plan...after I ride the blaster a full day without any hiccup...

 

[tnt01]

Getting ready to run the blaster,new carbs,riva head,factor b pipe...let see what this blaster could do with this set up