Block-offs for Pressure Test?

[Midlake Crisis]

What all do I need / where can I get all that is needed to block everything off properly for pressure testing the motor?

 

[Quinc]

I once used packaging tape and cardboard.

 

[Proformance1]

Fast Elements used to have a half way decent set a few years back but they werent cheap. Wat Con may still as well. Blowsion did but they are thin, more of a seal off for shipment. Most make their own.

 

[Big Kahuna]

Install head pipe. Get a plumbing seal. Either inflatable or the expanding types.

 

[Lumpy]

I used an old bike inner tube. One between carbs and intake and one between headpipe and manifold

 

[IS0LD0UT]

I used an old bike inner tube. One between carbs and intake and one between headpipe and manifold

Same here

 

[Kohldanielzimmer]

Same here

X3.

 

[Big Kahuna]

I used an old bike inner tube. One between carbs and intake and one between headpipe and manifold

Thats freaking ingenious!!!!!!

 

[Vumad]

If you want to make a kit, you can trace a gasket onto a piece of aluminum. Most places that sell the aluminum will cut the square to the size needed, then you just drill the holes from the gasket. I've also cut the aluminum down in my table saw.

That bike tube sounds like a simple fix. I haven't tried either.

 

[Lumpy]

Thats freaking ingenious!!!!!!

It was all I had at the time without venturing out. Worked great in a pinch and it was free.

 

[McDog]

With Boyesen intake and b pipe manifold all that is needed is some rubber plugs. I've never tried it on oem setup.