- Location
- wichita, ks
looking for a partnumber for breather tube for a rrp or atp pole from www.mcmaster.com any one have it? looked at lowes and homedepot and couldnt find what i needed.
breather tubes
- Thread starter bobob729
- Start date
- Location
- Victoria BC
try a pool supply store.
- Location
- Atlanta, GA
The rubber hose with the metal wire are hard to get a hold of at at local stores and I couldn't find it on mcmaster. I ended up just buying from thrust innovations. think it was like $25 for the two pieces. I wouldn't go for something else because you'll end up with water leaking into your hull...
I think at one point I did eventually find the manufacturer, its an industrial hose and you can't just buy like 2 or even 10 feet from them... its a big roll.
I think at one point I did eventually find the manufacturer, its an industrial hose and you can't just buy like 2 or even 10 feet from them... its a big roll.
- Location
- Washington
I just went to Home Depot and used pool cleaner tubing. Works great and 2.5" fit XS bracket.. Not sure about size holes on those. Only like $3 foot too
- Location
- bayarea, ca
I used pool hose also. Works great with a blowsion bracket
N3vrSat1sfied
Military Member
- Location
- Fort Worth, TX
I have two RRP hoses, slightly used. I could sell. I dont need them I went with pool hose and pvc couplers for a nice clean finish.
http://www.x-h2o.com/index.php?thre...3-eme-q8-sky-build.125077/page-4#post-1452739
http://www.x-h2o.com/index.php?thre...3-eme-q8-sky-build.125077/page-4#post-1452739
Vumad
Super Hero, with a cape!
- Location
- St. Pete, FL
I'm not sure about the rrp pole specifically but I found some duct tubing and some rv sewer tubing that could work okay. Vacuum tubing is a lot thicker and heavier.