Can my setup pull a 9/15 hooker?

[Jakobi86]

Have a sn with a 6m6/61x with dual 38's, protec head, and protec or psi pipe and manifold. ( it's the big over the top pipe that takes up the whole left side of the engine bay) and msd enhancer. Currently the ski rips and hits pretty hard just a little off the bottom. Looking for some more bottem end snap. Wondering if this setup can run that prop without issues. Not worried about top speed,
I can't keep the thing in control anyways at full throttle! Thanks


Sent from my iPhone using Tapatalk

 

[waksk8]

My sn 6m6 with a B pipe did great with a 9/15!

 

[Jakobi86]

Great, that's the response I was looking for! Did it give ya that right off
The bottem snap?

 

[tor*p*do]

my square nose ported 61x pushed a 10/16 hooker
then I blew the motor and went back to a ported piped 6M6 650 w/head, etc
and it spun the 10/16 fine
so you should have no issues
Hooker is the best for low end

 

[SuperJETT]

I even ran that with my 760 270lb ski setup, just a great all around prop.

 

[waksk8]

Great, that's the response I was looking for! Did it give ya that right off
The bottem snap?

Yes. Hit hard for a 650!

 

[JetManiac]

Yes, 9/15 works well on several of our customer's with all stock 650s.