FX-1 can someone help me find the fx1 pump converion threads?

[Shadow7874]

Do you just the one piece of the full thing?
I need all 3 of the black parts from this picture but im not 100% sure what is what. I read that it was all part of the oem X2 setup. Is it a steering nozzle, tilt nozzle, and reduction nozzle?

 

[special fx]

You'll need all 3 nozzle parts from an X2. Also, the 750 zxi shaft if different length.....only 900 and 1100 are the same.

 

[Shadow7874]

Does the shaft come with a polished section where the bearings go or does that develop after use?
I found this shaft which looks nearly new but im not sure about the bearing surface
http://cgi.ebay.com/ebaymotors/ws/e...ssPageName=VIP:watchlink:top:en#ht_500wt_1182
the price is great for the condition it seems to be in

 

[special fx]

it has a polished section and you should be able get a good, clean shaft for $30-$50 on average.

 

[Shadow7874]

Hmm, any idea whats up with the one i linked then? It looks very clean but has a dull finish all over and no polished section it seems.

 

[special fx]

Looks like someone glassbeaded it....I would pass since this hosed up the polished seal surfaces

 

[Shadow7874]

One more, hopefully final, question
What should i look for in a prop? my ski is stock but hopefully i can add a b pipe a few months after the pump swap

 

[special fx]

best bet for the $$ is to find good used SXR prop and have it machined for a 6mm setback.