Cold fusion risers

[Hallie]

hey,

I bought some cold fusion riser bars to go with the pro steering system. All looks nice till I go to bolt OEM start/stop on and the bar is too fat. Same with trim and throttle levers.

Anyone run theses bars?

 

[Pablo]

Use a dremel and hog out the inside of the s/s switch

 

[Hallie]

I thought of that for the start stop, but the levers are black anodised

 

[Hallie]

Ok slightly different tack, I'll buy RRP risers to finish this one off with the levers I already have.

Is there trim and throttle levers that will fit the cold fusion risers without having grind them out?

 

[TheCoz43]

Have you tried cold fusion?

 

[Hallie]

I was wondering that, do you know if Cold Fusion make throttle and trim levers that bolt up to their fat bars? I also heard that cold fusion = Blowsion risers, anyone know if this is true and had the same issue?

 

[eastcoastjumper]

I had the same problem with my rrp riser bars. They make those bar end extenders. I was going to buy those to get my width back So i didnt have to ruin my start stop switch. If you take off too much the thing spins

 

[Big Kahuna]

If you use Fat Bars, you will either have to run shorter grips, grind out the SS housing. or run extenders.