- Location
- Fort Mohave, AZ
Trying to see what jets people run in their Dasa carbs, not a single carb spec in the jetting thread. Anyone?
Does anyone run Dasa dual 48's
- Thread starter superhondaz50
- Start date
- Location
- sask, canada
If it's on a Dasa motor you should be able to get very good info directly from Dasa. I bought Dasa 48's for my 1200 and it came perfectly jetted and with the mixture screws set nearly perfect, just had to adjust them a touch for my elevation.
- Location
- Germany
Running DASA Dual 48's on my DASA 850SS.
Pilot: 140
Main: 105
N&S: 2,5
Spring: 95gr
Pilot: 140
Main: 105
N&S: 2,5
Spring: 95gr
- Location
- Fort Mohave, AZ
Is this your jetting or dasa's?
- Location
- Germany
Jetting from Brian (Thrust Innovations)
- Location
- Fort Mohave, AZ
OK got it. Finding jets specs for these carbs is giving me a headache lol I contacted Dasa but have yet to hear back. My carbs are jetted 130/130, I don't think its right for my setup.
same jetting I'm running in a dasa 5mm 918, but with 110 main. PFP, TL, 200psi, race fuel at 1000' elevation. Whats your setup?
Call or email DASA
- Location
- Wasaga Beach
Kyle at Dasa gave me my jetting for my 48's also. Email him or give them a call.
- Location
- Fort Mohave, AZ
Setup is a ported 760, 175psi, PFP, vforce 3, msd ignition. Called and emailed with no response. I'll try again my next break here at work.
- Location
- Annapolis, MD
I have Dasa 48's on my Jetmaniac 781 with RRP pipe:
Pilot: 122.5
Main: 135
N&S: 2.0
Spring: 80g
Pilot: 122.5
Main: 135
N&S: 2.0
Spring: 80g
- Location
- Fort Mohave, AZ
That's killer info there, that's real close to my setup. I was contemplating dropping in 135H and 125L. What are your screws at?
- Location
- Annapolis, MD
1 turn out on all screws seems to be the happy spot on my setup. Obviously every engine is different.
- Location
- Fort Mohave, AZ
Awesome, that's good info to get me to a starting point. How hard does your setup hit on the bottom?
- Location
- Annapolis, MD
It is pretty impressive for only being 781cc
- Location
- Germany
Setup is DASA 850SS, 48's DASA Carbs, MSD TL,RRP Pipe.185Psi PumpGas .
Is your Motor an old 850SS that you have make to a stroker?
I am thinking g about to make this.
- Location
- Fort Mohave, AZ
I checked the ns and spring, its 2.5 with a shiny spring which I believe is 65g. That's a stupid low pop off right?
- Location
- Fort Mohave, AZ
Is there a silver 115g?
- Location
- Wasaga Beach
I'm running a Dasa 908cc 5mm stoker with Dasa intake, Dasa 48's, Vf2's, PFP, and enhancer in my Blaster and this is my setup...Hope it helps.
135p
125m
2.5ns
115g spring
135p
125m
2.5ns
115g spring