Does this mod chamber look right?

[catfish4767]

I just purchased a complete b pipe set up from factory pipe and got it in the mail today. I've never seen a mod chamber before and was windier if this chamber is dented or if it's supposed to be like that before I called and complained. I tried to get the best picture I could without unwrapping it. The on the bottom side of the chamber

 

[catfish4767]

Other spots that appear to be dented too.

 

[58vwragtop]

Either that is not right or you got the "redesigned" 2015 model (2015 model consists of someone beating the crap out of it then shipping it!)

 

[Half flip95]

the one in the first and second pic are to clear the motor mount

the third one is hard to decifer with the plastic wrapping

 

[Lumpy]

Here's a pic of a mod chamber straight out of the box before I mutilated it

 

[Crab]

don't look right to me, bottom will have it tho.

 

[hondamxracer]

There's a few pics of a new mod chamber in this thread: http://www.x-h2o.com/index.php?threads/factory-pipe-is-this-a-mod-or-limited-setup.126208/

 

[jackmarcus]

Thats first picture looks seriously messed up, the metal looks like its crinkled

 

[yamanube]

Thats first picture looks seriously messed up, the metal looks like its crinkled

There is a clear plastic bag over it. Catfish, take the bag off and get some new pictures.

 

[catfish4767]

Thats first picture looks seriously messed up, the metal looks like its crinkled

It's still in the plastic....

 

[catfish4767]

That dent lines up to the motor plate right where it would rub if it wasn't there. I think pondracer was right

 

[Fro Diesel]

Open it, install it, and run it. After you get some brap, you will forget what the bottom side of the pipe looks like.

As others said, the dent is to clear the bedplate. While you have to stock pipe out, grind your bedplate a bit where the chamber could contact it.

 

[catfish4767]

Everything was finished and installed yesterday. I'll probably get some old turf down there and call it good. Thanks for the help

 

[yamanube]

Seriously, just grind the corner of the bed plate.