- Location
- Ahwahnee, CA
Driveshaft splines-run it of replace it?
- Thread starter Kohldanielzimmer
- Start date
Fro Diesel
creative control
- Location
- Kzoo
Do you have a cold fusion pump alignment tool? If so, run it.
If not, buy the cold fusion tool, then run it.
If not, buy the cold fusion tool, then run it.
- Location
- Ahwahnee, CA
I have one just wondering if the splines appear to be thinned out or compromised such that it would ruin the midshaft, resulting in decreased service life.
- Location
- Ahwahnee, CA
Input from anyone else?
- Location
- Long Island
Your mid shaft is probably in the same condition. Male/female. Run them til they strip then replace as a set.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
High Speed Industries
Your one stop shop for quality parts @highspeedind
- Location
- Lake Havasu City, AZ
Looks better than what's in my ski. Put that thing together and get on the water!
john zigler
Vendor Account
- Location
- wisconsin
I have seen much worse. You will be fine, as long as your alignment is spot on.
- Location
- New York Crew
marine grease, new orings and run it. looks okay but def water getting in there.
- Location
- Ahwahnee, CA
Thanks for the input guys.
- Location
- central florida
Once more, in case you overlooked proformance1's post: replace the o rings! Requires removal of midshaft assy. That is the only (!) thing keeping the splines lubricated. Pm me with your address and I'll send you a couple (free-since it's Christmas time)
It's only possible to replace those o rings by removing the midshaft hey?
Sent from my SM-G920V using Tapatalk
- Location
- central florida
Those o rings are hard enough to change out after you remove the assembly from the bulkhead, can't reach them through the driveshaft tunnel- at least I can't.
- Location
- Braapp factory
What size are the O rings Augustaf ? Worth carrying spares i reckon
- Location
- Ahwahnee, CA
According to my stalking of Augustaf's recent posting.... "mcmaster.com # = 9262k183, $11.13/ bag of 100. ( 2x18 mm, A70 Durometer)"
- Location
- central florida
mcmaster.com # = 9262k183, $11.13/ bag of 100. ( 2x18 mm, A70 Durometer) is what I use. Here in the US, mcmaster.com is convenient, but 2mm x 18mm , Buna N , not too hard, may be sourced where you are.
Sorry, just noticed #15 post, making this one superfluous.
Sorry, just noticed #15 post, making this one superfluous.
Thanks for the heads up! Found both mid shafts l own needed them.
So l bought a bag of them yesterday.Anyone that wants several,give me a shout.Would a $1.00 work shipped per 2 orings? Not trying to get rich,but would like to cover S & H.