Custom/Hybrid Gel coat and asphalt don't mix.

ImageUploadedByTapatalk1346709444.615362.jpgImageUploadedByTapatalk1346709462.235180.jpgImageUploadedByTapatalk1346709474.731415.jpgImageUploadedByTapatalk1346709488.948368.jpg
30 mph brake lockup and ski slides under my truck from trailer. Made me sick to my stomach when I saw the corner smashed up after throwing 10k into a ski. Please chime in on what u would do to fix this, I wanna do it right and get it back to looking like it showed up in the crate. Thanks
 

chadetroit

Get Wet
Location
Bay Area, CA
Ugggg, sorry to see that. On the bright side it doesn't look like any major cracking or anything structural. I say either epoxy fill or fairing filler for the gouges and hit with some gloss black and clear. Not gonna be perfect but at least it will cover it up. Looks like most of it is underside, after a few beachings those should blend in. Could always be worse... GL
 
What kind of trailer did you have it on that it just simply slid off the trailer? I have been in some pretty bad scenarios a couple times and never had a properly strapped down ski do more than maybe move a couple inches....
 

Fro Diesel

creative control
Location
Kzoo
Tell me about it. I lost a ski at close to 100mph. Bad rear ball joint on a car with 4wheel steering. Ground the chinpad, left handlebar, Pole, and Wdk hood really bad. Completely ground off my two pissers and bilge fittings. But other than replacing the bars and outlets the ski was fine and performed with excellence...that looks bad now but
Put some surf time on that beast and you will blend it perfectly.

sent from Fro Diesel using tapatalk2
 
Top Bottom