Blaster Good vent tubes/tubing?

[stagesrt4]

What are all the options out there for down tubes that come off the blaster hood.

The stock tubing doesn't work to well with the 1100 motor.

I'm sure there's lots of custom stuff people have done, post pics if you have any please.



I rotated the front one n trimmed it so that one firs fine now but rear comes down on top of the arrestor.

Thanks

 

[motoman3000]

I've seen 701 industries advert one

 

[701dave]

Thanks Motoman. Yes this kit was actually developed on my own 1200 B1. Once you cut the factory tubes, the hull fills so quickly when the ski is rolled over. If you get separated from the ski in the surf for even a minute, its pretty much game over . So much water in the hull makes them wallow and near impossible to remount. Check them out in my on-line store. http://www.701industries.com/shop/#!/AirDown-System/p/49689247/category=8399405

 

[billglass]

put those on over the winter. makes it alot easier dealing with closing the hood and working on the ski. I had to always make sure the back tube slide in it's space properly. I totally forgot about them and just remembered when I did a submerged circle over the weekend, NO BOGGING from water being injested into carbs. NICE! That was one of those after the fact realizations. +1 for these for a variety of reasons.

 

[jpweeks173]

@stagesrt4 I just turned mine like you did and jammed another piece of hose inside the stock hose so it goes as deep into the hull as possible. It clears my mod pipe no problem. Blocked off the rear intake. Never had a problem with water ingestion. Easy cheap and simple.