Captain PegLeg
GJP
- Location
- Villa Rica, Ga
I just got my pro tec half girdle head in and i went down to install it, but hit a stopping point when i realized i have a few questions. Kinda need the answers quick cause i'm covered in grease! Thanks!
1) When taking off the stock head, there is 2 wires coming from the head to the ebox. Wha are these and what do i do with them?
2) The head i bought has the orings in it already, and they have no tears or anything, so i am gonna try to put it on with the ones that are on there. Should i put a thin little bit of gasket maker (yamabond) along the orings, or put a little grease on them, or put them on dry?
3) I looked for some torque specs on this head and i could find them. I was just gonna use the ada specs. But does anyone know what i should torque the head bolts, girdle bolts, and the base bolts?
1) When taking off the stock head, there is 2 wires coming from the head to the ebox. Wha are these and what do i do with them?
2) The head i bought has the orings in it already, and they have no tears or anything, so i am gonna try to put it on with the ones that are on there. Should i put a thin little bit of gasket maker (yamabond) along the orings, or put a little grease on them, or put them on dry?
3) I looked for some torque specs on this head and i could find them. I was just gonna use the ada specs. But does anyone know what i should torque the head bolts, girdle bolts, and the base bolts?
