help need with 760 motor

[terenceferguson]

650 and 760 motor ?s
k i have a 91 superjet 650, i just put in a 760 motor. everything went in good, there are just a few different things between to 2 motors.

The 650 head has 1 hose going into it and the 760 has two, how do i hook up the other side?

The 650 has like a sensor that goes in the top of the head and there is a bracket that holds it down, but the 760 has no holes to bolt it to the head.

The 650 motor had like a 1/4'' hose going from the exhaust to the head but the 760 has no where to hook it up at on the head?

It started right up and sounded normal. If any one knows what i should do with these couple things id really appreciate it. Thanks

 

[terenceferguson]

pic

here is a pic if it works.

 

[Matt_E]

I believe that's the motor I shipped you, right?

You can go two ways with the head cooling outlets (they are not inlets)
1. Use only one and plug one. That's what I did.
2. Tee both of them together into a single line or use two lines to two pissers.

About the temperature sensor: Don't hook it up. That's the easiest solution. (What I did).

Line to exhaust: Plug the line to the exhaust. I do not believe it's needed.

 

[terenceferguson]

so i can just run a hose from the front cyclinder and tee it into the rear hose, or how would i hook it up to 2 pissers

 

[Matt_E]

Just run one hose to each pisser.
I'd just block one though.