- Location
- Algonquin, IL
Super Jet "Hot Tuna" squarenose build
- Thread starter jeepinxj
- Start date
- Location
- Fresno CA
That is what I figured. I like those
Is a mesh sticker that lets air through but not water.
Sent from my iPhone using Tapatalk
- Location
- Algonquin, IL
One sponson has been made! What a pain in the arse
- Location
- Algonquin, IL
Got some more done on the rear and both sponson done and foamed.
155 pump will be going in as well
Got my hpe 4 mil kit ready to go in!! Need to finish porting the cases but cylinder is done!
155 pump will be going in as well
Got my hpe 4 mil kit ready to go in!! Need to finish porting the cases but cylinder is done!
- Location
- Algonquin, IL
More pics of cylinder
Vs stock
Vs stock
Last edited:
- Location
- Algonquin, IL
More work finally got done. Note to self don't do 2 rockers at the same time!!! I'm liking the lines so far
- Location
- Algonquin, IL
Sponsons started need to glass over
- Location
- Algonquin, IL
155 pump shoe is in!
- Location
- Algonquin, IL
Sponsons are now glassed
- Location
- Algonquin, IL
Sponson almost finished
- Location
- Algonquin, IL
Slow but steady
- Location
- Algonquin, IL
Updates!!!!
- Location
- Algonquin, IL
- Location
- Washington
awesome build, when you glassed your tray back in how many layers did you use? gonna defoam my sn here soon
- Location
- Algonquin, IL
I kept the main piece on the bottom then used 3m panel bond to put back together. Once dried I used 1 layer of 1708 bias then 2 layers of weave over the entire tray
- Location
- Algonquin, IL
READY FOR PAINT!!!!
- Location
- Algonquin, IL
That would be awesome!