Blaster how to mount blockoff for exhaust?

[imoto228]

putting in rear exhaust outlet in my blaster and wondering how to mount the block off plate and the new outlet. should i 5200 and rivet? or use screws? pics are nice too

 

[Waveblastermaster]

i used the factory rubber gasket with the screws, and for safe measure i used a little 5200 around the outside

 

[extreemthrottle]

i used the factory rubber gasket with the screws, and for safe measure i used a little 5200 around the outside

agreed. use the blockoff plate with the stock rubber gasket, and screws, then a little 5200 to help seal it up.
the outlet i would use some good stainless screws, and 5200 to install it, if it doesnt have a backing plate. also predrill the holes slightly so the fiberglass doesnt splinter and crack.

 

[Jpass]

agreed. use the blockoff plate with the stock rubber gasket, and screws, then a little 5200 to help seal it up.
the outlet i would use some good stainless screws, and 5200 to install it, if it doesnt have a backing plate. also predrill the holes slightly so the fiberglass doesnt splinter and crack.

Same here

 

[imoto228]

it got it all in. everything went smooth. thanks for help!!!