Is there a bilge pump mount for snsj?

[aimsmall]

Hi guys, I just ordered a "complete" bilge pump kit for my 1990 super jet. It got here and there's no mount for the bilge pump despite one being shown in the picture. I ordered from explosive powersports. I received a Lorenz & Jones kit part number 3048017.

It came with the pump, hose, hull fitting, wiring including bar mount switch and billet bracket for the switch, what I don't see is a mount for the pump?

Any info on where to get one and or how you guys installed them on pre 95' superjets would be helpful. Thank you.

 

[Barbieri972]

They don't make one that I know of for the smaller midshaft, plexus works good or 5200 I have heard to glue it

 

[aimsmall]

Thank you Barbier, I was worried that's what I might hear, if anyone has pics of how they were able to make it work that would be helpful too.

 

[E350]

In 2015, I installed two in our 1994 SN SJ. One off the bulkhead wall where the midshft goes through. I ordered a couple of different brackets and sent them back until I got one from Blowsion that would hold a Rule 500. It is tight, but works fine and I had to drill and extra bolt hole and do a little bit of grinding if I recall.

The other I installed off the fuel tank hold down in front of the engine.

The Rule 500 I installed near the midshaft looks like it touches but it does not. Pretty sure it was this Blowsion which I modified by drilling another hole in the bracket. You take the bottom off the rule 500, then rivet it to the bracket, then bolt the bracket (with the new hole you have drilled) to the bulkhead, then you pop the Rule 500 into its bottom which is riveted to the bracket:

https://www.blowsion.com/catalogsearch/result/?q=Bilge+Pump+Single+Mount+-+Superjet+06-01-152

In fact, I think both brackets may be the same Blowsion bracket. I just totally cut down the bracket that I installed in front of the engine and drilled a hole to attach it to the fuel tank hold down.

 

[aimsmall]

Thanks E350, that's helpful, I wish the mags made the brackets in different colors so it'd be easy to figure out which one works with minimal modifications.

 

[Barbieri972]

The midsHaft on a 94-95 is bigger like a round nose but the gas tank hold down would work!!

 

[X2Kid]

I had a peek at one of my SN's (a '93) today and I'm happy to report it is fitted with a bilge bracket quite obviously designed for this specific 'ski. As it was already on there when I bought it I can't advise on brand or part number. However, if you can track down any 650 SN's being parted out I imagine you'd find one running this style of bracket.

I wouldn't be too fussed if it was a bit rough in appearance - with the coupler cover installed so little is visible I didn't even bother trying to take an image. Oh, and I hope you like it anodized purple as everything from the early 90's was