JETTLab Pressure Test Block Off Plate Kits with High Quality Rubber Seals

[Vortex]

Still have these in stock?

 

[DAG]

Yup, in stock

 

[grezzmky]

blockoff's for 44mm carbs? ok to order carb plates, b pipe and exhaust plates

 

[DAG]

blockoff's for 44mm carbs? ok to order carb plates, b pipe and exhaust plates

Yes and yes

 

[SuperHumanJetski]

Pm'd

 

[E350]

I don't do Facebook. How can I buy a carb and exhaust leak down plate kit for a Kawasaki 650?

 

[Mdavies_02]

Wish these were still around. Any left in stock?

 

[twisterad3]

Wish these were still around. Any left in stock?

tbh, I found these didn't seal all that well. And the gasket cracked pretty easy when clamping them down tight enough to not get air leaks.

 

[jo5hi3]

tbh, I found these didn't seal all that well. And the gasket cracked pretty easy when clamping them down tight enough to not get air leaks.

You need to grease or "lube" the sealing surface so it doesn't pinch the gasket.

 

[twisterad3]

You need to grease or "lube" the sealing surface so it doesn't pinch the gasket.

Sure did. Tried with marine grease and wd40.

 

[Jyzmbe]

I love mine. Been using them for a few years. They seal and work just fine for me


Sent from my iPhone using Tapatalk

 

[Mdavies_02]

I love mine. Been using them for a few years. They seal and work just fine for me


Sent from my iPhone using Tapatalk

Sounds like you don't need them anymore. Send them my way

 

[Yami-Rider]

Used mine many times over the years, works perfect.

 

[fx1mark]

I have a home made set. I use home made gaskets but you could use any gasket. If you are leaking I would think you can flip it over and use a regular gasket. To be clear, I install this sandwiched between the carb-manifold and exhaust-manifold.

 

[G-Body]

These were discontinued just before I needed a set of pressure test plates. I meant to make up a nice set out of aluminum but never got around to it. I took the slacker way out, grabbed some half inch plywood that was laying around and made a crude set out of that. They actually sealed with cereal box used as a gasket, but for future use I picked up a roll of 1/8" neoprene rubber which has worked very well.

 

[mikidymac]

Pretty easy to make them yourself. I still have an old Group K kit that’s just the rubber then you sandwich it between the exhaust manifold and carbs so no need for fancy plates. A made some other sizes using sheet neoprene rubber and a gasket as a template.