BrightE's
Paul
- Location
- Seattle, WA
I just installed 2 high and 2 low speed T-Handle screws from Jetworks into my stock 38's on my '04 RN, and the T-handle section of the screw is bottoming out on the aluminum carb housing before the screws seat fully. Thus I can't tell where 0 is and don't know how many rotations out I am when tuning.
Is the solution just to cut the surrounding aluminum off the housing or do I have a set out of spec T-Handle Screws?
Is the solution just to cut the surrounding aluminum off the housing or do I have a set out of spec T-Handle Screws?