Other McMaster part # needed

[Shonuff]

So I've ordered this wrong TWICE now so I'm needing help.

This is off my ZXi 1100 head.

I'm trying to order a replacement ones without the flush fitting. A 90* elbow, a 45* fitting, and a straight one.

I ordered 3/8" inside diameter but the fitting is way too big.

Thanks.

 

[Mark44]

What NPT 1/4" for what hose ID?

 

[Shonuff]

3/8 ID NPT with 3/8 ID hose

 

[Mark44]

90 deg. 3/8" ID hose 3/8" NPT 5346K19
45deg. 3/8" ID hose 3/8" NPT. 53525K18
Straight hose to threaded male 3/8" ID hose 3/8" NPT 53525K48

http://www.mcmaster.com/#catalog/117/266/=frgqk8

 

[Mark44]

3/8 ID NPT with 3/8 ID hose

Not sure what 3/8: ID NPT means I assume the hose is 3/8" ID with 3/8" NPT threads.

 

[SuperJETT]

Do you have a Parker store in that massive megalopolis you call home? If they don't have it in stock, they can get it.

 

[Shonuff]

90 deg. 3/8" ID hose 3/8" NPT 5346K19
45deg. 3/8" ID hose 3/8" NPT. 53525K18
Straight hose to threaded male 3/8" ID hose 3/8" NPT 53525K48

http://www.mcmaster.com/#catalog/117/266/=frgqk8

That is exactly what my most recent order was. The fitting, however, is too big for the head. The ID is 3/8" but the OD is much larger.

That's my issue.

The items you listed are 100% my newest (incorrect) order.

 

[DangerBoy]

That is exactly what my most recent order was. The fitting, however, is too big for the head. The ID is 3/8" but the OD is much larger.

That's my issue.

The items you listed are 100% my newest (incorrect) order.

you need either 1/8 npt or 1/4 npt x 3/8 barb use measurements below

Nominal pipe size (in) --- Pipe outer diameter --- Threads per inch
1⁄16 -- 0.3125 in (7.94 mm) -- 27
1⁄8 -- 0.405 in (10.29 mm) -- 27
1⁄4 -- 0.540 in (13.72 mm) --18
3⁄8 -- 0.675 in (17.15 mm) -- 18
1⁄2 -- 0.840 in (21.34 mm)-- 14

db

 

[Mark44]

That is exactly what my most recent order was. The fitting, however, is too big for the head. The ID is 3/8" but the OD is much larger.

That's my issue.

The items you listed are 100% my newest (incorrect) order.

Its probably 1/4" npt then not 3/8" They are not aking for the ID of the threaded end just the hose that goes on the barb.