Need 08 SJ rideplate information

[Matt_E]

Is the 08+ SJ ride plate the same as the old Squarenose plates, with six bolt holes?
Are the holes in the same locations as the Squarenose plates?
Thanks.

 

[Crab]

Is the 08+ SJ ride plate the same as the old Squarenose plates, with six bolt holes?
Are the holes in the same locations as the Squarenose plates?
Thanks.

I have one from a square if you need it.

 

[Matt_E]

I might...is it a stocker?

 

[Proformance1]

I was told by Kevin at Wamiltons that it will bolt to a pre 08 hull just by drilling the two cast in areas out. SN or not, No cule

 

[Matt_E]

That's what I am after.
When I shortened my RN hull, I put the back two inserts into the same location as the middle inserts in a SN hull. This means I must use SN plates.
I guess I can also use 08+ Plates.

 

[DK-Freestyle]

A TBM '08+ ride plate bolted right up to my square nose vintage race ski.

 

[Matt_E]

Sweet, that's what I wanted to know.
Thanks D!

 

[Watty]

A stock 08+ plate is identical to the 96+ with the exception of the middle bolt holes. They are in the same location as the SN ones.

 

[JetManiac]

The stock superjet rideplates are the same size and same basic casting for all years of superjets.

SN stock rideplates have 6 smaller holes which can be drilled out and used on RN and '08-up sjs.

RN '96-'07 stock rideplates have 4 larger holes but the spots are there to drill for the middle holes. Can be used on '08-up by drilling the middle holes out. Can be used on a SN as is with 4 bolts or drill middle holes and use all 6.

RN '08-up stock rideplates have 4 larger holes but the spots are there to drill out the rear holes. Can be used on SN or pre-'08 RN after drilling out rear holes.