- Location
- Ontario Canada
Need help agian
- Thread starter Jordancaird
- Start date
- Location
- Ontario Canada
Nvm got it srroy
- Location
- Canberra, Australia.
It looks like you might have to remove the cylinder to gain access to those.
- Location
- Ontario Canada
Nope its a hell of a time I had to take out the starter and I could just get one it with a wrench and there and keep flipping and going from the top and going 1 24th of a turn at a time and the other I could only turn like 1 100th of a turn but the mani is slotted so it slides up an u can bump it up and then I could loosen the other one licoriceing bad design it's really hard to tighten it back on like that without ripping the gasket because you pretty much have to tighten those bottom bolts and force at down
- Location
- Ontario Canada
I guess it corrected my f word lol
New language?
Jcary85
Site Supporter
- Location
- Glenmoore pa
I think folks usually switch to a smaller 10mm head bolt in those two spots. Jetmaniac probably sells them.
Big Kahuna
Administrator
- Location
- Tuscaloosa, AL
You have to grind a wrench to fit, just like you do on the B Pipe Manifold. Just have to turn a little at a time. also a thin box end side can work, the newer chromed wrenches (Craftsman) are a lot thinner than the older style (Forged look) and may can get in there with the boxed side.
- Location
- Ontario Canada
Hahaha your so funny ......not really lol
Just trying to say this is a forum,we are not all texting each other
I’m not trying to be a dic,ok Just write stuff out
Last edited: