Super Jet need help! manifold question

[waksk8]

I am starting to put my SN back together after parting it out to build my Chan. I have a 701 but I have found a protec pipe that is 62t. Will the protec pipe for a 62t fit the 61x?

 

[Blue]

62t uses larger 10mm bolts than a 61x at 8mm bolts so the manifold would not center itself properly. It could be made to fit if u center it before tightening it down but if it was not aligned properly u may have water leaks even possibly leaking water into the exhaust port. Best to find the right manifold.

 

[waksk8]

62t uses larger 10mm bolts than a 61x at 8mm bolts so the manifold would not center itself properly. It could be made to fit if u center it before tightening it down but if it was not aligned properly u may have water leaks even possibly leaking water into the exhaust port. Best to find the right manifold.

Thats what I needed to know. thanks

 

[TheBuzzard]

you can put a sleeve over the 8mm bolts and that will center it in the 10mm manifold holes. like the sleeves that come on the stock trim nozzles on yamaha or similar

 

[waksk8]

you can put a sleeve over the 8mm bolts and that will center it in the 10mm manifold holes. like the sleeves that come on the stock trim nozzles on yamaha or similar

that had crossed my mind just wasn't sure about making the sleeve.