On a Quest about this time last year a thread was started "http://www.x-h2o.com/threads/3715" because a new hoodseal was discovered by yamaslut, which is claimed to be better than the OEM hoodseal, However knowone could get into contact with the distributer. To make a long story short, I have been talking with the guy at Britech and finely got a 3' sample sent.
I am making this thread to see if their is still an interest with this, MUCH cheaper and "better than oem" hoodseal. The only down side is they dont make it in small quantities. A minimum of 250 feet :bigeyes: has to be ordered at a time. The price i would sell it would be around $12 and come in about 8 foot sections plus a flat rate (most likely USPS Priority) shipping. This is the gasket w/o the 3M backing as the tape adds double the cost and not as good as DAP contact cement.
Last but not least this will fit nearly all model jetski's. Not just a Superjet. check dimisions to make sure it will fit in your ski's hoodtrough
Below are a few pictures of the 3' section i sampled ..pics might take a few seconds to load
Pic of seal placed (not glued) in hood channel to show tight fit
Pic of seal installed
easily bends around corners w/o squashing up
Showing pictures of how the gasket wraps up and out the lip of the hood once latched.
If theirs enoulf interest i'll start making a list of pre-orders :biggthumpup:
