Oil Fill Block off Plates W/ & W/O Primer Hole

[ChadGnarly]

i had some oil fill block off plates made to fill that void in your fuel fill area. They are cut on a water jet from aluminum and fit perfectly in place of where the oil fill neck was. i have them with and without a hole for the primer plunger. jazz up your gas area. they are as they seem in the pictures, and they fit perfectly in my ski with the use of the stock screws. only come in the color seen in the picture, aluminum.

20 shipped for either one

PM with any questions

 

[JustinB]

Wait, what are these for exactly?

 

[poopski]

Looks like there for an X2, I think?

 

[ChadGnarly]

yes they are for the X2 and make you fuel fill area look a little better after you eliminate the the oil tank

 

[ChadGnarly]

here is a poor quality shot of one installed

 

[Cannibal]

Nice. I built my own, took a couple hours to layout, cut and drill, test fit, modify...... I would have gladly spent the $20 instead.

 

[CDR]

Nice. I built my own, took a couple hours to layout, cut and drill, test fit, modify...... I would have gladly spent the $20 instead.

Tell me about it I would of gladly payed $20 then spent 2 hours of my life cutting apart a stop sign!