Surfriding One man surf or lake loader......homemade

[W8kski]

Just wanted to share a home made job that I did that was very easy to do after seeing a few other ski carriers and loaders. I'm sure it's been done. I took one side of an extended atv ramp, flipped it over, drilled holes in the sides every few rungs, and installed some rollerblade wheels on both sides. Works out great for me to load an unload myself at the beach. I need to trim a little bit on the crossbars at either end, and it will be perfect. Winch strap reaches the ski when its sitting at the base of the ramp which makes it easy to load. Drilled two holes at the top flat piece that sits on the bunks, as well as through the bunks. Install two push pins to keep it in place while loading an unloading. You can still use it as an atv ramp when you flip it back over.

 

[mattyboy89]

thats a good idea. its nice seeing a dual purpose setup like this without the need to know how to weld

 

[SmittySX]

I need one of those like 30 feet long with a winch at the end so i can launch at the house! lol

 

[tor*p*do]

this is a must have in those locales with low water levels
or poor boat ramps/beach

 

[Dfan1]

I like how you set your trailer up to haul 1 or 2 skis , I wouldn't mind seeing a pic of what kind of bracket you used to gain the height in the center.