oops!! ouch!!!

[matt333]

ok so i think i may have just made a not so cheap paper weight. i put my cases together and i thought i had all the crank pins aligned. well i didnt and here is what happen. anyone know if this is fixable or am i screwed? :banghead:

 

[suva]

I'd be more woried that you tweaked the surface where the bearing sits or the rest of the case than right where it tried to punch through.

 

[junkyardj]

i wouldent run that ever!!


you should send them to me so i can properly dispose them

 

[5810]

use them for porting practice LOL

 

[matt333]

they are already ported. so not even if i push the dowell back threw and epoxy it back in there? they use epoxy when they port cases. if i remember right people use to epoxy the cases to fit stroker cranks.

 

[5810]

U can try, but u might have a air leak, if u decide to run these cases make sure u pressure test the motor.

 

[junkyardj]

U can try, but u might have a air leak, if u decide to run these cases make sure u pressure test the motor.

why would you get a air leak?

it goes to the bearing and after that there is two seals i would think the only thing to worry about is if its warped

after its cleaned up of course

 

[SUPERTUNE]

Yes, just grind out the area where the dowel tried to punch through, use a punch and get the pin back in place, then be very clean with a patch of JB weld and sand smooth and be careful to line up the pins and put it back together.

 

[matt333]

cool thanks guys!!