- Location
- Fort Worth
will a laydown pipe fit in a square? going to put a stupid big motor in a square but still wanna use a b pipe.
PFP in a SN
- Thread starter jetpilot36
- Start date
- Location
- Stouffville, Ontario
Assuming that last bit is a typo and you meant to say PFP. I rode with fellow GTA'er that had a PFP with a 760 in a SN. It fit.
- Location
- Fort Worth
well i would like to keep my b pipe in there but if the engine builder says b pipe is not enough then ill have to go with a laydown pipe.
Quinc
Buy a Superjet
- Location
- California
You can bore the bpipe out to 48-50mm to get a little more brap out of her.
- Location
- Fort Worth
I think they do have a smaller hose. And a smaller tube. If I put a 900 in it, I'll have to change the exhaust tube. Didn't think about that. That tube is tiny. Its a 6m6. 1990.
Sent from my SM-N975U using Tapatalk
Sent from my SM-N975U using Tapatalk
DAG
Yes, my balls tickled from that landing
- Location
- Charlotte, NC
I put a DASA 1100 in a SN. Worst decision i ever made. Pump tunnel is not going to handle the power.
It wont matter as long as you are running some kind of waterbox. The sound will be a little higher pitched. A TPE with a laydown pipe will probably overpower a 144 pump at low speeds.
- Location
- Fort Worth
- Location
- Fort Worth
how does it run? stock pump?
DAG
Yes, my balls tickled from that landing
- Location
- Charlotte, NC
Cavitation
I’ve never got it to cavitate yet, stock pump with solas concord 13/19, I think I’m too tall and have a new one to try out. I plan on getting another am hull someday so just playing around right now
Quinc
Buy a Superjet
- Location
- California
Put a torrent 150 in her.