Piranha rideplate and intake

[TheNewLakeSkater]

I know I know. I should have done more research before I bought a Piranha hull. But now I’m stuck with this thing and trying to figure out where to find a ride plate and intake grate that will fit. A superjet intake looks like it would work if it were ground down in the front. But does anyone have a lead on a ride plate?

 

[TheBuzzard]

Put a superjet ride plate under there and see if it fits

 

[TheNewLakeSkater]

Put a superjet ride plate under there and see if it fits

It definitely will not. The one that’s needed for the piranha is way wider. I have a feeling it may be similar to a rickter but I’d need someone to take measurements to confirm that.

 

[TheBuzzard]

Measure the width. Couch plates are wider. I have a stack of plates. Most AM hulls take SJ plates and grates unless some A hole made the junk so you had to buy theirs. Just like AM hulls needing SJ motor mounts. MAke the junk.to use couch mounts that are a dime a dozen.