surferdude345
X-H
- Location
- Blacksburg for school
Anybody had experience with the protech Modified 44s? What did you think? The only thing i can tell they do is taper bore them is anything else modified?
Thanks
Thanks
Pro-tech Carbs
- Thread starter surferdude345
- Start date
#ZERO
Beach Bum
- Location
- Florida - U.S.A.
The throttle plates are 44mm and the top of the carb is 44.5mm, how much improvement do you think it will make?
If your bore both sides of the carb without altering the venturi diameter and install larger throttle plates, you might improve the signal and increase the air flow.
If your bore both sides of the carb without altering the venturi diameter and install larger throttle plates, you might improve the signal and increase the air flow.
SUPERTUNE
Race Gas Rules
- Location
- Clearwater Fl.
Yes, THEY WILL RUN VERY NICE! I used them for years Chris! (#.0):highhorse: They might be a little old school, but for most of you freestyle guys, they will work a lot better than a lot of this newer stuff!
Just make sure the throttle blades and shafts are in good shape and not beat out from the shafts not shimmed up correctly.
If these are the real 'MCCOY' from Pro-Tec with the Mo-Flow 2 piece adapters and taper bored all the way out to the edge of the adapters they will not be disappointing when they are jetted right for the engine combination.
Just make sure the throttle blades and shafts are in good shape and not beat out from the shafts not shimmed up correctly.
If these are the real 'MCCOY' from Pro-Tec with the Mo-Flow 2 piece adapters and taper bored all the way out to the edge of the adapters they will not be disappointing when they are jetted right for the engine combination.
Last edited:
#ZERO
Beach Bum
- Location
- Florida - U.S.A.
I'd save your money and get a set of Chucky modified 46mm carbs. :biggrin:
Even the new 48mm Novi freestyle carbs are lookin' nice. :burnout:
Even the new 48mm Novi freestyle carbs are lookin' nice. :burnout:
crammit442
makin' legs
- Location
- here
surferdude345
X-H
- Location
- Blacksburg for school
I have these carbs already - they need new throttle plates and a rebuild im trying to judge if its worth the money. I got them for pretty cheap.
Chuck yea they are the real protec- with the 2 part adapters and what not. Judging from what you said its seems like they might be worth building back up.
Chuck yea they are the real protec- with the 2 part adapters and what not. Judging from what you said its seems like they might be worth building back up.
surferdude345
X-H
- Location
- Blacksburg for school
i dont have a camera at school but they are on the website which i cant rember - Basically they are taper bored from the flame arrester adapter to the venturi.
crammit442
makin' legs
- Location
- here
Get any pics yet?
surferdude345
X-H
- Location
- Blacksburg for school
No camera here at school - they look like the silver 44s - but taper bored nothing else looks different then a normal carb. And they have a matched adapter